&
WARNING:
Risk
of
unsafe operation.
If
engine does
not
start
after
two
pulls, squeeze trigger
of
gun
to
relieve pump pressure. Pull starter
cord
slowly
until resistance is felt. Then
pull
cord
rapidly
to
avoid kickback
and
prevent
hand
or
ann
injury.
NOTE:
If
the oil level
in
the engine is low, the engine will
not
start.
If
the
engine does
not
start, check
the
oil level and add oil as needed.
11
. Depress trigger
on
gun to start water flow .
.&.
WARNING:
Risk
of
unsafe operation. Stand on a stable surface
and
grip gun/spray wand firmly with both hands. Expect the gun
to
kick when
triggered.
12. Release trigger to stop water flow .
.&.
WARNING:
Risk
of
injury from spray. Always engage
the trigger
lock
(OJ
when
gun
is
not
in use. Failure
to
do
so
could
cause accidental spraying.
SHUTTING
DOWN
1. After each use,
if
you have applied chemicals, place
detergent siphon hose into container
of
clean water and
draw
clean water through chemical injection system
to
'---------==----'
rinse system thoroughly.
NOTICE: Risk
of
property
damage.
Failure
to do
so
could cause damage to
the
pump.
2. Turn engine off. See Engine
Owner's
Manual.
NOTICE: Risk
of
property
damage.
NEVER
tum the water off with
the
engine
running.
3. Turn water source off.
4.
Pull trigger
on
spray gun
to
relieve any water pressure
in
hose
or
spray gun.
NOTE: Failure
to
release system pressure will prevent removal
of
high pressure
hose from spray gun
or
pump
connection.
5. See Storage section
in
this manual for proper storage procedures.
MAINTENANCE
&
WARNING:
Risk
of
burn hazard.
When
performing maintenance, you may
be
exposed
to
hot
surfaces, water pressure
or
moving
parts
that
can cause
serious injury
or
death .
.&.
WARNING:
Risk
of
fire hazard. Always disconnect, spark
plug
wire,
let
the engine cool
and
release all water pressure before perfonning any
maintenance
or
repair. The engine contains flammable fuel. Do
not
smoke
or
work
near open flames while performing maintenance.
To
ensure efficient operation and longer life
of
your pressure washer, a routine
maintenance
schedule should
be
prepared and followed.
If
the pressure washer is
used in
unusual conditions, such as high-temperatures
or
dusty conditions, more
frequent maintenance checks
will be required.
ENGINE
Consult the Engine
Owner's
Manual for the manufacturer's recommendations
for any and
all maintenance. NOTE: The engine drain plug
is
located
at
the
rear
of
the unit.
16- ENG
To Next Page
Loading...
