Simpson MSH3224 - Page 9

•
Connect Spray
Wand
to Spray
Gun
Thread the spray wand into
the end
of the spray gun.
•
Release Air from
System
Release
all air from
pump and high pressure
hose
by depressing
trigger until a steady
stream
of water is present.
Approximately
30 seconds.
•
Connect QC
Nozz.les to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
~
•
Verify
the Engine
Switch is turned
to the ON
Position
See Label #8 on
the engine.
CD
Pull the Recoil Starter
Grip
Pull the recoil starter
grip
to start the engine.
CD
Push the
Choke Pin to
the OPEN
Position
See Label #10 on the engine.
Gradually move
the Choke
Pin to
the
OPEN Position
after engine starts.
See Label
#11 on the
side
of the engine .
•
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
•
Verify
the Choke
Pin is Pulled Out
to the CLOSED
Position
The Choke Pin has been
preset by the factory
to be
in the CLOSED Position.
See Label
#9 on the
side
of the engine.
.& WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's
manual before using this product.
9- ENG