Radome (bottom)
Rubber foot
Mounting base
Washer
Spring washer
M10 Hexagonal bolt
Included
Tighten the four bolts
to 20 Nm
Installation 1-6 Radar scanners DX45/60
as listed on page 1-3. Use silicone to secure the bolts.
1.2.3 Connecting cables
(length of cables – see chapter 4. Specifications)
Run the cables by following the instructions below:
• Do not bind the cable for the radar collectively with cables of other equip-
ment (especially the power supply cable).
• Run the radar cable along the ship’s hull or wall surface, and fasten it at
intervals of about 40 cm.
• The scanner side of the radar cable has to be fitted inside the radome
scanner, see Interconnecting cable next page.
• The power cable delivered with the display unit must be fitted with two fuses
before connecting the radar scanner (see fuse types in specifications).
• After fitting the Interconnecting cable:
The radar cable has a connector fitted on the display side. Push the connec-
tor as far as it will go into the receptacle marked ‘RADAR’ on the rear of the
display cabinet and turn the connector’s coupling ring clockwise until it is
tight.
To Next Page
Loading...