Simrad DX45 - Compass and Wind Interface Setup

Ż
GOTO
Water Compass Waypoi
PLOT
Ź
Apparent wind input:
Group selection: SIMRAD
Source (none available):
NONE
Calculated true wind input:
Group selection: SIMRAD
Source (none available):
NONE
MENU
Exit Accept
ENT
Ʃ
Ʃ
Wind
Ż
GOTO
Navigation Water
PLOT
Ź
Input:
Group selection: SIMRAD
Source (one available):
Simrad RC35 ,Sn:000035
Use COG as internal heading: NO
MENU
Exit Accept
ENT
Ʃ
Ʃ
Compass
Setup menu Chapter 9-19
PLOT
Go to Compass interface - step back with [GOTO]
Source - indicates that there is one source available: Simrad RC35.
Use COG as internal heading - if no compass is connected, you
can use the course (COG) from the built-in GPS module by changing
NO to YES.
) When using the GPS course as replacement for heading input, the
accuracy will be reduced in relation to speed, wind and current.
PLOT
Go to Wind interface - step back with [GOTO]
Source - will indicate how many units are connected and available.