What to do if Simrad HALO 5000 Marine Radar scanner detect fails?
If the Simrad Marine Radar scanner detect fails, it could be due to an interruption in communication between the pedestal and the R5000 processor. First, verify that the pedestal is receiving power. Next, with the R5000 processor powered on, check if the Ethernet LEDs are flashing. Finally, check the Ethernet connections.
Why is there transceiver performance loss in my Simrad HALO 5000 Marine Radar?
The performance monitor may indicate a degradation of at least 10dB on TX and/or RX in good weather conditions. If it is a false alarm, and you have a good radar image, clean the antennas and check the cabling between the performance monitor module and antenna. If the alarm is valid, and you have no or poor visibility, check for traces of water inside the pedestal.
What to do if Simrad HALO 5000 shows motor drive fault?
If your Simrad Marine Radar shows a motor drive fault, begin by restarting the pedestal. If the alarm persists, switch off the system and try to rotate the antenna by hand.
What causes PSU overheat in Simrad Marine Radar?
PSU overheat in your Simrad Marine Radar is caused by the power supply's temperature being too high. To resolve this, restart the pedestal, wait 5 minutes, and then let the pedestal operate for at least 1 hour.
How to fix motor driver error in Simrad HALO 5000 Marine Radar?
To address a motor driver error in your Simrad Marine Radar, first, restart the pedestal. If the issue continues, replace the motor and gear.
What causes PA soft over heat in Simrad HALO 5000 Marine Radar?
PA soft overheat in Simrad Marine Radar occurs when the power amplifier temperature is too high. To resolve this, restart the pedestal, wait 5 minutes, and let the pedestal work for at least 1 hour.
Why am I getting a zero bearing fault on my Simrad Marine Radar?
A zero bearing fault on your Simrad Marine Radar indicates that the azimuth reference is missing. To fix this, open the pedestal, check the azimuth cable, and clean the optical sensors.
What does bearing pulse fault mean on Simrad HALO 5000 Marine Radar?
A bearing pulse fault on your Simrad Marine Radar means that the azimuth data is missing. To resolve this, open the pedestal, check the azimuth cable, and clean the optical sensors.
What to do if Simrad HALO 5000 shows PSU voltage error?
If your Simrad Marine Radar displays a PSU voltage error, it means the power supply's voltage is wrong. To fix this, restart the pedestal and try again.
What to do if Simrad HALO 5000 Marine Radar shows PSU power issue?
If your Simrad Marine Radar indicates a PSU power issue, it means the power supply's power is too high. To resolve this, restart the pedestal and try again.
General| Weather Mode | Yes |
|---|---|
| Type | Solid-State Pulse Compression Radar |
| Frequency | 9.4 GHz |
| Range | Up to 72 nautical miles |
| Antenna Size/Length | 4ft or 6ft |
| Display | Requires external display (Simrad MFD recommended) |
| Target Tracking | Yes, with MARPA |
| Antenna Rotation Speed | 24/36/48 RPM |
| IP Rating | IPX6 |
To Next Page
