12
5 Remove the mounting template.
6 Apply the supplied Tef-Gel
®
anti-corrosion gel to the four feet of the pedestal.
7 Lift the pedestal using the supplied lifting strap.
⚠
WARNING: Do not lift the pedestal with the antenna attached.
8 Lower the pedestal carefully so its mounting holes align with the drilled holes in the vessel.
9 Place a at washer and spring washer onto each bolt.
¼ Note: If you are installing the pedestal onto a steel surface, also use the supplied plastic isolating washers.
10 Apply the Tef-Gel
®
anti-corrosion gel to the threads of each bolt.
11 Insert the bolts through the drilled holes and into the pedestal’s threaded mounting holes. Tighten the bolts securely.
¼ Note: The torque settings for the mounting bolts are 30 N.m – 40 N.m (22.1 lb-ft – 39.5 lb-ft)
To Next Page
Loading...
