13
12 Apply the Tef-Gel
®
anti-corrosion gel to the thread of the Ethernet connector.
13 Connect the 8-pin end of the Ethernet cable to the pedestal. Take care to align the connector correctly to avoid bending
the pins. Secure the collar by rotating clockwise.
14 Connect the 3-pin power cable to the pedestal. Take care to align the connector correctly to avoid bending the pins.
Secure the locking collar by rotating clockwise until it clicks.
¼ Note: The cables must exit straight out from the pedestal without sharp angles that could strain the connections. Secure the
cables to the ship’s structure to protect the connectors from any strain in all conditions before connecting the cables to the
pedestal.
To Next Page
Loading...
