Simrad HALO 5000 - Troubleshooting; Error Code 0 x00001 Persistence Corrupt; Error Code 0 x10001 Zero Bearing Fault; Error Code 0 x10002 Bearing Pulse Fault

14
Fit the antenna to the pedestal
⚠ WARNING: Do not operate the radar without the antenna connected.
1 Remove the waveguide protection cap from the pedestal and the waveguide protection label from the underside of the
antenna.
¼ Note: The cap and label prevent contaminants from entering the waveguide. Only remove these covers just before tting the
antenna to the pedestal.
2 On the antenna, check the sealing ring is correctly positioned in the groove around the waveguide.
3 Apply the supplied Tef-Gel
®
anti-corrosion gel to the entire length of each of the four antenna studs.