Simrad HALO 5000 - Error Code 0 x1000 D PA Soft Overheat; Error Code 0 x1000 E PA Hard Overheat; Error Code 0 x1000 F GW Data Path Error; Error Code 0 x10010 PSU Overheat

15
4 Carefully lower the antenna on to the pedestal.
¼ Note: The antenna can only t one way.
x 4
5 Place a at washer then a spring washer followed by a dome nut on to each of the antenna studs.
6 Tighten the dome nuts using a socket and torque wrench to 15 N.m (11 lb-ft).
¼ Note: Using a socket and torque wrench minimizes the risk of damaging the powder coated surface of the pedestal.