Simrad MX510 User Manual (English)

Other manuals for Simrad MX510

Questions and Answers:

M
Mary MendozaJul 30, 2025
What to do if Simrad MX510 won't track satellites?
- J
  John WilsonJul 30, 2025
  If your Simrad Car Navigation system isn't updating its position and the red traffic light is blinking for more than 10 minutes, the issue might be due to jamming from nearby transmitters. Try relocating the GPS antenna. It could also be a faulty antenna or cable, in which case you should replace the antenna. As an alternative, connect the MX421 power directly to the external 12 VDC supply. If the issue persists, the unit may need repair.
V
vincentcaldwellAug 4, 2025
Why is there no data output to peripheral equipment from my Simrad MX510 Car Navigation system?
- K
  Kaitlyn AllenAug 4, 2025
  There can be several reasons why your Simrad Car Navigation system is not outputting data to peripheral equipment: * The NMEA output data may not be configured correctly. * The NMEA version might be wrong. * The output rate or format could be incorrect. * There might be an issue with the electrical standard. * Too many data sentences might be turned on, causing throughput overflow. * There might be more than one NMEA talker on the circuit. * The port could be faulty. * The MX420 requires the user to enable NMEA. If none of these are the cause, the unit may need repair.
D
Diane WrightAug 7, 2025
How to troubleshoot a Simrad MX510 with a black LCD display?
- J
  James WalkerAug 8, 2025
  If your Simrad Car Navigation system shows a black LCD display and no traffic light, you should check the supply voltage, verify that there is no reverse polarity, inspect the wire installation, and check if the external fuse is blown.
B
Brandi WardAug 12, 2025
What to do if Simrad MX510 is tracking satellites but not updating position?
- R
  rebeccabrownAug 12, 2025
  If your Simrad Car Navigation system is tracking satellites but not updating its position (red traffic light is solid), it could be because the DGPS mode is set to DGPS Only and no corrections are being received. Check the maximum cable length restrictions and cable conditions, especially if the satellite signal is weak. It could also be caused by weak GPS satellite signals. If the satellite signals are weak, return the unit for repair.
T
taylorcynthiaAug 16, 2025
Why does my Simrad Car Navigation system show a battery low alarm?
- J
  Joshua Greene DVMAug 17, 2025
  If you're getting a battery low alarm on your Simrad Car Navigation system, the external battery may be low. Check the power supply voltage and installation.
J
Jeffery JohnsonAug 21, 2025
Why does my Simrad MX510 lose all data at power up?
- T
  tylerharrisAug 21, 2025
  If your Simrad Car Navigation system loses all data when powered up, the backup battery is likely dead. Replace the internal backup battery.
M
matthew27Aug 25, 2025
What causes no keyboard response on Simrad MX510 Car Navigation system?
- A
  Anna RamirezAug 26, 2025
  If your Simrad Car Navigation system has no or partial keyboard response, the issue might be due to corrupted memory, a faulty keyboard, or a faulty processor. In any of these cases, return the unit for repair.

Simrad MX510 Specifications

General

GPS	Yes
Chartplotter	Yes
Sonar Support	No
Wi-Fi	No
Bluetooth	No
Update Rate	1 Hz
Voice Guidance	No
Lane Guidance	No
Speed Limit Warning	No
Points of Interest	Yes
Traffic Information	No
Weight	0.5 kg
Display Size	5 inches
Protocols	NMEA 0183
Operating Temperature	-15°C to 55°C
Storage Temperature	-20°C to +60°C
Map Coverage	C-MAP