Wpt & Rte Input - Uploading Waypoints into the MX51x
This screen enables the input data port to receive waypoints and routes from a chart
plotter, PC (VMS), or other device to the MX51x. You can receive this data through any of the
user NMEA 0183 input data ports. Load the WPL sentences first, then the RTE sentences.
Change Transducer Connected from No (default) to Yes and select the appropriate port.
Refer to the Waypoints - Uploading Waypoints from Other Devices section of this manual
for more details on the software interface. Refer to the Installation section of this manual
for hardware interface.
Turn the WPT & RTE In option to No after the waypoint and route banks have been downloaded to
prevent an inadvertent change of the MX51x memory bank.
To Next Page
Loading...
