1. - 3.
4.
5.
6.
www.svb.de / Copyright SVB-Spezialversand Bremen 3
1. Press the “Menu” button twice
2. Select “Network”
3. Select “Sources”
4. Select “Auto Select”
5. Select “Start”
6. The device will now commence an automatic scan
Source Scan
The source scan is used to determine all devices located on an NMEA System.
Please note that all devices must be turned on and the NMEA2000 network
must be supplied with a 12V power supply.
Follow these steps to begin a source scan:
To Next Page
Loading...
Need help?
General
