Simrad MO16-T - User Manual

Questions and Answers

A
amy26Aug 13, 2025
How to fix picture quality and image stability issues on my Simrad MO16-T?
- S
  Susan WeeksAug 13, 2025
  Check the condition of the video cable to ensure the shield is intact and the cable does not exceed the maximum distance for the video standard. Also, verify that the signal source is outputting a compatible resolution at a supported frequency. The monitor may be receiving incorrect or bad sync signals from the source, or the video may be compromised by interference from other equipment.
R
Raymond BurkeAug 17, 2025
Why does my Simrad MO16-T Monitor have vertical shaded bars on the screen?
- C
  cdeleonAug 17, 2025
  If your Simrad monitor displays vertical shaded bars, the incoming video may be in a 4:3 ratio. You can either leave it in ‘aspect’ mode or set it to ‘fill’ to use the full screen space.
J
Julie RiosAug 20, 2025
Why is the backlight low on my Simrad MO16-T Monitor?
- S
  Scott LesterAug 20, 2025
  A low backlight on your Simrad monitor can occur if the supply voltage has dropped below 10V; it will restore at >11V. It can also happen if the unit has been subject to excessively hot direct sunlight for an extended period, or if the unit enclosure is too hot, which enables automatic thermal protection.
C
Claudia YoungAug 25, 2025
What causes slight distortion in text or graphics on my Simrad MO16-T Monitor?
- J
  Joseph ColeAug 25, 2025
  Slight distortion in text or graphics on your Simrad monitor can occur if it is not working in its native resolution. If possible, adjust the video source to output the correct resolution.
R
Randall BrownAug 28, 2025
What to do if the display is present but bars appear or roll across the screen of my Simrad MO16-T?
- A
  Anthony OliverAug 28, 2025
  The issue of bars appearing or rolling across the screen on your Simrad monitor can be due to a ground loop problem between the video source and the monitor. It can also be caused by video being compromised by interference from other equipment.
A
Austin SanchezSep 1, 2025
What to do if my Simrad MO16-T Monitor has no picture and the red LED is OFF?
- M
  Michelle SmithSep 1, 2025
  First, ensure that the Simrad monitor is connected to an appropriate DC voltage source and that the fuse is properly fitted or the breaker is switched on. After pressing the power button, the red LED should blink as the monitor starts up, followed by a brief display of the logo on the screen.
M
Mitchell NguyenSep 5, 2025
What to do if my Simrad MO16-T Monitor has no picture and the red LED is ON?
- A
  Arthur ThomasSep 5, 2025
  A continuously lit red LED indicates that no compatible video is available on the currently selected source. Here are some things to check: * Confirm that the correct video input is selected. * Check that the video signal cable is properly connected to the display. * Test the cable with known good equipment. * Check the display settings of the video source to ensure the resolution is supported by the display. * Ensure the brightness is turned up to a suitable level.
L
lindacarsonSep 8, 2025
How to fix image persistence on Simrad Monitor?
- J
  James WolfSep 9, 2025
  To erase an image ghost on your Simrad monitor, turn the monitor off for several hours. To avoid this condition, do not leave the monitor displaying the same image unnecessarily for an extended period.