|
3
RS90S | QuickStart Guide - EN
Switching a wireless handset ON:
• Press and hold [X] until the display illuminates.
The display shows “Searching” then “Connecting,” and then the current operating screen.
¼ Notes:
• This only switches on the individual wireless handset, not the transceiver.
• If the transceiver is off, the wireless handset continues to display “Searching”.
• At install time, wireless handsets must be subscribed. See “Subscribing a wireless
handset” in the User’s Manual.
Switching a wireless handset OFF
¼ Note: This procedure only switches off the wireless handset. It does not switch off
any other handsets or the transceiver.
1. Press and hold [X] until the following message appears “Release key to power off.”
2. Release the [X] key.
Screen Icons
The following illustration shows a typical operating screen
in standby mode. The radio is in standby mode when it is
waiting to send or receive calls.
During normal operation, the following icons may be
displayed on the screen depending on setup:
Symbol Meaning
or
Channel suffix
AIS is enabled
Flashing if a weather alert has been received (US models only)
ATIS is enabled
Low battery warning. Activates at 10.5 V
Incoming DSC call. Flashing if there are unread call log messages
Canadian channel bank is selected
, ,
Favourite channel 1, 2 or 3 is selected
The current channel is a duplex channel
DSC is enabled
42.408
33.122
012
DSC
Hi
INT
DISTRESS
WPT: HARBR
128
t
8.00
n
m
0.50>
5
Kt
55
N
E
275
UTC
14:43
PRI
t
To Next Page
Loading...
Need help?
General
