SAL R1a Easy Tank User Manual No. 703852
703852A04, SIMRAD SAL R1a Easy Tank User Manual.docx 9 (25)
3 USER GUIDE
Figure 1: The settings of the display (SD4-3 Menu) and the settings of the speed log (R1a
Menu) are physically separated. The speed log settings are reached by Remote Connect
from the display meny.
3.1 General
The SAL R1a is normally conducted from the SD4-3 display on the bridge. If more than
one SD4-3 is installed, one of them shall be designated as the Speed Log Master Display,
which means that it is the remote display for the WTU menu in the SAL R1a speed log.
This SD4-3 is to be labelled “Master”. Same SD4-3 display or another SD4-3 display can
also remotely control other slave SD4 displays e.g. dimming function (See Basic System
Information in Section 1 General).
The Main Unit - ELC (Electronics Cabinet), which due to the TRU-cable length is
mounted in the vicinity of the Bottom Parts, has fuses and indicating LEDs, which can be
checked if a system failure occurs. (See TROUBLE-SHOOTING GUIDE)
SD4-3 Menu system
Local display settings
SAL R1a Menu system
Speed log settings
Remote connect
To reach speed log settings
To Next Page
Loading...