Issue 4.0 17/09/03 SIMRAD
4
1 INTRODUCTION TO THE TP10, TP20 AND TP30 TILLERPILOT
The TP10, TP20 and TP30 Tillerpilots combine highly sophisticated electronics with advanced
software and powerful mechanical drive to provide accurate and reliable steering performance
under a variety of different conditions with minimal current consumption.
TP10 – is suitable for tiller steered sailing yachts up to 10M (34 Ft) in length.
TP20 – offers the same facilities as the TP10 and is fully compatible with the Navico Corus
instrument system to provide a complete navigation system. Options offered include connection to
an external compass, wind sensor or navigational receiver together with additional remote control
facilities.
TP30 – offers the same facilities as the TP20 with an improved re-circulating ball screw drive and
is suitable for tiller steered sailing yachts up to 12.8M (42 Ft) in length.
The main components of the Tiller Pilot are listed below:
Electronics PCBs
Early versions
TP10 PCB (TP10 only)
TP30 PCB (TP 20 & TP30)
Current Versions. The same PCB is used for all products. The wiring
loom carrying the NMEA data is left disconnected in the TP10.
TP10 / 20 / 30 Re-engineered PCB (Common to all)
Mechanical Components
General Assy : TP10
General Assy : TP20
General Assy : TP30
To Next Page
Loading...
Need help?
General
