TLU 600/610
Page 14/20
NOSP 14540-04 (JULY 2011)
The battery can be subjected at some hours of slow load, without damage, but the
permanent charge is not advised.
The energy source of the remote controller is a moulded block NiMH 7.2V nominal,
1800 mAh, joining safety elements and carrying the label bellow
In case of failure of the block battery, it’s necessary to replace the block by a same
block battery, only supplied by Simtronics, to keep the ATEX protection
3.4.6.
3.4.6.3.4.6.
3.4.6. B
BB
B
ACK
ACKACK
ACK
-
--
-
LIGHTING
LIGHTINGLIGHTING
LIGHTING
The remote controller is fitted with a screen back-lighting system which provides
excellent legibility regardless of ambient lighting conditions.
Back-lighting can be turned on and off using the button at the bottom left of the
remote controller (see Figure 2, page 5).
3.4.7.
3.4.7.3.4.7.
3.4.7. A
AA
A
UTOMATIC CUT
UTOMATIC CUTUTOMATIC CUT
UTOMATIC CUT
-
--
-
OFF
OFFOFF
OFF
The remote controller has an automatic cut-off system to conserve battery life.
This system is activated 3 minutes after the last key press or whenever the
connection to a remote sensor has been broken for over 3 minutes.
To Next Page
Loading...