Simu T5EHz - Compatible Transmitters; Transmitter Location Guidance; End Limit Adjustment Procedures; Learning Mode Setup

1 : 1/5 channels Wall Hz transmitter/ Memory Hz
2 : 1/5 channels Mobile Hz transmitter
3 : Color Multi 16 / Timer Easy / Timer Multi transmitters
4 : Hz Sun sensor
Location of the PROG key on Hz transmitters:
Do not position the transmitter near metal in order to avoid
range losses.
Compatible transmitters
3
4.3- Adjustment of the end-limits - memorizing the end points:
The end limits of the T5EHz are adjusted in 4 different ways depending on the following conditions :
- Bottom slat stop or not, rigid* or exible link between the rolling shaft and the shutter.
End limit adjustment
4
>>
ON
2s
1A 2
a
OK 4.3
OK 4.3
b
>> >>
>> >>
>>
>> >>
A
*V.A.R
V.A.S
Easylink
OctoEasy
B
*V.A.R
V.A.S
Easylink
OctoEasy
C
D
4.1- Learning mode:
- Switch ON the motor.
- Simultaneously press the UP and DOWN keys of a Hz transmitter. The
motor will run for 0,5 second in one direction and then in the other.
The transmitter now controls the EHz motor in unstable mode. Go to
stage 4.2.
1- Simultaneously press the UP and DOWN keys of a Hz transmitter. The
motor will run for 0,5 second in one direction and then in the other.
2- Press the "stop" key for 2 s. The motor will run for 0,5 second in one direc
-
tion and then in the other. The operation is completed. Go to stage §5.
4.2- Checking the rotation direction:
Press the UP key of the transmitter:
a- If the motorized tube runs in the UP direction , go to next stage (4.3).
b- If the motorized tube runs in the DOWN direction, reverse the rotation direction by pressing the Stop key for at least
3 seconds. The motor will run for 0,5 second in one direction, then in the other direction. Move to the stage 4.3.
If the installation includes several motors, only one motor is to be powered during this programming
procedure. It will avoid interferences with the other motor during the procedure.
2/5
1 2 3 4
(12 transmitters max. for one motor)
EN