Fan speed: Press FAN SPEED to display the current wind
speed. AUTO, LOW, MED and HIGH can be selected. The
default state is high fan speed for the unit without medium
fan speed.
Economic operation: This icon will be lightened or off when
pressing ECO button.
NOTE: All the above icons will be displayed only when
the remote controller is electrified for the first
time or reset.
OPERATION INSTRUCTIONS
Install and replace batteries
Install 2 pieces of 7# alkaline batteries.
Slide the cover to install batteries and make sure to
place them in right pole.
AUTO operation
Switch on the power and running indicator light on indoor unit
flashes.
1. Press MODE to select AUTO.
2. Adjust temp via and . Generally the range is 17 ~30 .
3. Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on AUTO mode and fan
speed is AUTO which is nonadjustable.
4. ECO is effective on AUTO operation.
COOL/HEAT/FAN operation
1. Press MODE to select COOL, HEAT or FAN.
2. Adjust temp via and . Generally the range is 17 ~30 .
3. Press FAN SPEED to select AUTO, LOW, MED or HIGH.
4. Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on the set mode. Stop
operation via ON/OFF.
NOTE: On FAN mode, temp is nonadjustable and ECO is
ineffective. Procedure 2 is omitted.
DRY operation
1. Press MODE to select DRY.
2. Adjust temp via and . Generally the range is 17 ~30 .
3. Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on DRY mode. Turn off
the unit via ON/OFF.
4. On DRY mode, ECO and FAN SPEED are unavailable.
Timer operation
TIME ON and TIME OFF are used to turn on and turn off the
unit at the set time respectively.
TIME ON operation
1. Press TIME ON, icon SET, HOUR and ON are lightened.
2. Press TIME ON again and adjust the time.
3. Keep pressing this button, the time will increase by 0.5
hour. When the set time exceeds 10 hours, pressing the
button will increase the time by 1 hour.
4. 0.5s after setting, remote controller will send TIME ON
command to the unit.
TIME OFF operation
1. Press TIME OFF, icon SET, HOUR and OFF are lightened.
2. Press TIME OFF again and adjust the time.
3. Keep pressing this button, the time will increase by 0.5
hour. When the set time exceeds 10 hours, pressing the
button will increase the time by 1 hour.
4. 0.5s after setting, remote controller will send TIME OFF
command to the unit.
To Next Page
Loading...
Need help?
General
