Example of Timing setting
Yes
No
Yes
No
Main page
▼
Press “FUNCTIONS” key twice to enter hour
setting interface of “Timer 1 On”
▼
▼
▼
Press “ ” key to enter minute setting interface of
“Timer 1 On”, adjust the minute number to be 10
Press “ ” key to enter hour setting interface of
“Timer 1 Off”, adjust the hour number of “Timer 1
Off” to be 12
Press the “▲” or “▼” key to set the hour
number of “Timing 1 On” to be 07
Press “ ” key to enter minute setting interface of
“Timer 1 Off”, adjust the minute number to be 30
The setting steps of “Timer 2” and “Timer 3” are the same as “Timer 1”,
after setting all the settings then press “OK” key, the 3 timing periods will
be effective.
“Timer 1” setting
failed, after 7
seconds, the
page shift to the
main page.
Successfully set the On time of
“Timer 1” to be 07:10 and Off time
of “Timer 1 Off ” to be 12:30, then
back to the main page.
Finish setting the On time of
“Timer 1” to be 07:10 and Off
time to be 12:30, then enter the
setting of “Timer 2”.
Whether press “OK” key
Whether press “ ” key
During any period of timing setting to press “OK” key , the timing periods which have been set will be
effective (only if the “On” and “Off” of one timing period have been set, the setting is effective).
Check timing information: to check the timing which has been set, press “ ” or “
▲
” key under main page,
the “ On ”and “ Off ” time of Timer1, Timer 2 and Timer3 will be displayed in turns.
Cancel timing: press and hold “CANCEL” key for 3 seconds, then all the effective timing periods will be
cancelled.
Note: Correct: To avoid timing error, each period of timing should not be crossed. E.g.:
Correct:
To Next Page
Loading...
