Need help?Do you have a question about the Sindoh 3DWOX-1 and is the answer not in the manual?
General| Filament Diameter | 1.75 mm |
|---|---|
| Print Technology | Fused Filament Fabrication (FFF) |
| Nozzle Diameter | 0.4 mm |
| Heated Bed | Yes |
| Auto Bed Leveling | Yes |
| Weight | 20 kg |
| Connectivity | USB, Wi-Fi, Ethernet |
| Supported Materials | ABS, PLA |
| Software | 3DWOX Desktop, Cura |
Instructions to prevent severe injury or death if not followed.
Instructions to prevent property damage or minor injury if not followed.
Precautions regarding the machine's hot components to prevent burns.
Precautions to prevent electric shock while operating or maintaining the machine.
General precautions to prevent injuries during machine operation.
Guidelines for proper installation of the machine.
Cautions regarding hot parts, proper operation, and California-specific chemical notices.
Step-by-step guide for printing models from a USB flash drive.
Procedure for cooling the bed and safely removing printed objects.
Steps to take if the printer does not turn on.
Procedures for cleaning the printer's components and interior.
Resolving errors related to sensors, motors, fans, and temperature.
Troubleshooting issues with filament transfer, loading, unloading, and detection.
Resolving problems when filament fails to come out of the nozzle.
Procedure to clear filament cut within the nozzle assembly.
To Next Page
