Sindoh 3DWOX-1 - Machine Specifications Overview

Preparations for Machine Operation
1-2
1
1. Machine Specifications
1.1 Printing
Printing Method Fused Filament Fabrication
Max. Print Length(mm) W(max):210, D(max):200, H(max):195
Print Layer Thickness Setting 0.05~0.4mm
Basic Nozzle diameter 0.4mm
Filament width 1.75mm
Printable materials * PLA, ABS(Sindoh)
* PLA, ABS, ASA, PETG, etc(open material)
Bed leveling Auto measuring + Manual leveling
* Soft filaments(flexible, TPU, nylon) can’t be used in this machine.
* Using filament containing abrasive additives (e.g. metal component, carbon fiber) may cause the breakdown
of the machine and will shorten its life time drastically.
1.2 Temperature/Speed
Continuous Nozzle Usage/ Maximum Temperature Recommended Temperature(Nozzle): PLA 200℃,
ABS 230℃ / Max 250℃
Continuous Bed Usage/ Maximum Temperature Recommended Temperature(Bed): PLA 60℃,
ABS 90℃ / Max 110℃
Recommended printing speed/maximum speed 40mm/s Recommended / 200mm/s max
* Continuous operation at maximum temperature can cause malfunction, Please use in case of nozzle
clogging or other troubles.
1.3 Machine
Power 150W
Dimensions 421 x 433 x 439
Weight 15kg
Port USB Device, USB Host, Wifi, Ethernet
Cartridge Auto Load / Unload
1.4 Software/Support
Supported Software Sindoh Exclusive Slicer
Supported File Format *.stl, *.ply, *.obj, *.amf, *.gcode
Supported Operating System Windows 7 or above, Mac OSX 10.10 or above
Recommended Memory Requirements DRAM 4 GB+
Note
- Graphics must support OpenGL 2.0 or higher.
1.5 Default Setting of Print layer Width
Nozzle Width 0.4mm
Print Layer Width 0.2mm