Need help?Do you have a question about the Sindoh 3Dwox DP200 and is the answer not in the manual?
Most program functions are available in this menu bar.
Covers the 3D model view, its position, size, and rotation controls.
Allows selection of different viewing modes: 3D Model Viewer, Support Edit Viewer, Layer Viewer.
Describes how to load printable 3D models into the program.
Explains how to configure various parameter values for slicing.
Shows information on filaments inside the printer.
Covers printer settings, adding printers, and network monitoring.
Explains how to load 3D model files using the LOAD button.
Covers setting parameters and executing the slicing process.
Details three methods for printing: USB Thumbdrive, Network Connection, Local Network.
Allows manual addition or deletion of support structures.
Analyzes the 3D model for potential printing problems like thickness and overhang.
Calculates and recommends the most optimal printing direction for the model.
General| Filament Diameter | 1.75 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Print Speed | Up to 100 mm/s |
| Bed Temperature | Up to 100°C |
| Connectivity | USB, Ethernet, Wi-Fi |
| Supported Materials | PLA, ABS |
| Printer Dimensions | 421 x 433 x 439 mm |
| Technology | Fused Deposition Modeling (FDM) |
| Software | 3Dwox Desktop |
| Power Requirements | AC 100-240V, 50/60Hz |
| Build Volume | 200 x 200 x 185 mm |
| Layer Resolution | 0.05 - 0.4 mm |
| Display | 4.3-inch color touchscreen |
To Next Page
