16
Basic Parameter Setting
Click on the [SETTING] button to change any parameter values.
eg) change the slicing layer height value which does determine the quality of the printable or adjust
the support application.
Slicing
After checking 3D model is positioned on the bed, selecting Layer Viewer mode will apply the
parameter values and execute the slicing.
The result of slicing in the layer view will be displayed on screen.
Model will not be a whole instead will be displayed in lines of layers, using the slider located at the bottom,
user is able to analyze each layer of the model.
Slider to move to the desired layer
Current layer on screen
Total layer number
To Next Page
