2-53
UI Menu Function
2
Caution
-
Improper usage of a third-party filament may cause device failure and poor printing quality.
Therefore, it is important to create a correct gcode and apply it to a device by fully understanding
the characteristics of a third-party filament, including the recommended printing temperature and speed.
-
As soft filament with shore hardness of 65 D or less (TPU, TPE, etc.) may cause transfer problem, it is
not applicable.
A filament containing abrasive additives (metal component, carbon fiber) may cause transfer problem
and reduce the service life of nozzles.
-
If a third-party filament has a too large spool, it would not be usable with it inserted.
Make sure that the spool to be used has the width of 67 mm or less and an outer diameter of 213 mm
or less.
5 “OPEN MATERIAL” is displayed at the bottom of the main screen.
Although the 3DWOX 1 supports open material mode, we recommend the use of Sindoh filament on the printer.
The filament available for use in Open Material Mode is shown below.
Filament Bed Preparation
Recommended
Nozzle Temp(℃)
Recommended
Bed Temp(℃)
Remark
PLA N/A 200 60 Sindoh / 3rd party
ABS N/A 230 90 Sindoh / 3rd party
PETG N/A 230-250 80 3rd party
ASA N/A 235-255 110 3rd party
To Next Page
Loading...
