Singcall APE560 - Sound Length and Voice Reporting Times Setting; Volume Adjusting; Different Sounds for Different Pagers; Time Setting

5) Press the key [ENT], and [F3] appears.
6) Press the key [ESC] and back to standby mode.
◆Sound length and voice reporting times setting
1) Standby mode, press the key [FUN] for 3 seconds and [F1] appears on the screen.
2) Use the key [UP] to choose [F4].
3) Press the key [ENT] and [01] appears on the screen.
4) Use the key [UP] or [DOWN] to choose the length of sound you want. Numbers “01”-“15”
mean 15 kinds of the length. “01” means 2 seconds, “02” means 4 seconds, and so on. Number
“15” means 30 seconds of the music prompt. Numbers “01”-“15” also means the times of the
voice reporting.
5) Press the key [ENT], and [F4] appears again.
6) Press the key [ESC] and back to standby mode.
◆Volume adjusting
※Only for APE9000, APE9300, APE9500 and APE9600. (The volume of the other models can be
changed with the volume controlling knob on the top of the receivers.)
1) Standby mode, press the key [UP] or [DOWN] to choose the volume, 01~15 means 15 kinds of
volumes.
2) Press the key [ESC], and back to standby mode.
◆Different sounds for different pagers
(Not suitable for APE1900/APE2100/APE2900/APE8000/ APE8800)
1) Standby mode, press the key [FUN] for 3 seconds and [F1] appears on the screen.
2) Press the key [UP] to choose [F5].
3) Press the key [ENT] and [01] or [12] appears on the screen.
4) Use the key [UP], [MOVE] or [DOWN] to choose a sound.
5) Press the key [ENT] and [01] or [001] appears.
6) Use the key [UP], [MOVE] or [DOWN] to choose the number you want.
7) Press the call pager, and the number flashes on the screen with sounds and then stop.
8) Press the key [ESC] and [F5] appears again, the registration is finished.
9) Press key [ESC] again to back to standby mode.
10) Repeat step 4) ~8) if more than one pagers needed to be registered.
◆Time setting
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Use the key [UP] to choose [F5] (for APE1900/APE2100/APE2900/APE8000)
For receiver APE1200/APE1800/APE2000/APE2300/APE2500/APE2600, time could be set in the
last function choice (F8 or F9).
3) Press the key [ENT] and set the current time, for example [13-29] displays on the screen,
4) Use the key [UP], [MOVE] or [DOWN] to adjust time.
5) Press the key [ENT], and [F5] appears again.
6) Press the key [ESC] and back to standby mode.