Step 7: Threading Tips for the Serger
• Use good quality serger thread. This thread is sold in
larger 3000 yd. spools at most fabric and sewing retailers.
• Use the same brand of thread in all tensions, do not mix
and match brands.
• Use the same size spools on all cone adapters that are
located at the back of the machine when threading your
serger.
• Try to avoid black thread; it tends to cause static, leading
to skipped stitches. Use a dark grey or navy instead. If
you must use black, then thread-up the needles with
black, but use grey or navy in the loopers.
To Previous Page
