Singer 7466 - Performance Checklist; Needle

80
5. PERFORMANCE CHECKLIST
GENERAL PROBLEMS
Machine does not sew.
* Power switch is turned off. - Turn on the switch.
Machine jams/knocks.
* Thread is caught in hook.
- Clean hook (see page 74 - 75).
* Needle is damaged. - Replace needle (see page 26 - 27).
Fabric does not move.
* Presser foot is not lowered
- lower presser foot.
* Feed dog control is lowered (see page 16 - 17).
STITCHING PROBLEMS
Machine skips stitches.
* Needle is not all the way up into needle clamp.
- See page
26 - 27.
* Needle is bent or blunt.
- Replace needle (see page 26 -
27).
* Machine is not threaded correctly.
- See page 20 - 21.
* Thread is caught in hook. - Clean hook (see page 74 - 75).
Stitches are irregular.
* Needle size is not correct for thread and fabric.
- See page 26
- 27.
* Machine is not threaded correctly.
- See page 20 - 21.
* Top thread tension is too loose.
- See page 28 - 29.
* Fabric is being pulled or pushed against machine feeding
action.
- Guide it gently.
* Bobbin has not been wound evenly.
- Rewind bobbin.
Needle breaks.
* Fabric is being pulled or pushed against machine feeding
action.
- Guide it gently.
* Needle size is not correct for thread and fabric. - See page 26
- 27.
* Needle is not all the way up into the needle clamp.
- See page
26 - 27.
THREAD PROBLEMS
Thread bunches.
* Top and bobbin threads are not drawn back under presser
foot before starting seam.
- Draw both threads back under
presser foot about 4 inches (10 cm) and hold until a few
stitches are formed.
Needle thread breaks.
* Machine is not threaded correctly.
- See page 20 - 21.
* Top thread tension is too tight.
- See page 28 - 29.
* Needle is bent. - Replace needle (see page 26 - 27).
* Needle size is not correct for thread and fabric
- See page 26
- 27.
Bobbin thread breaks.
* Bobbin case is not threaded correctly.
- See page 18 - 19.
* Lint accumulates in bobbin case or hook.
- Remove lint
(see page 74 - 75).
Fabric puckers.
* Top thread tension is too tight.
- Adjust thread tension
(see page 28 - 29).
* Stitch length is too long for sheer or soft fabric.
- Shorten
stitch length.