20
Service Manual
Removal:
1- Remove the face plate cover and arm top cover.
2- Turn hand wheel sufficiently to appear the screw (A). Loosen it. Turn again to
appear the screw (B). Loosen it also.
3- Slide take-up lever assembly (C), take-up stud (D) and needle bar connecting link (E).
Replacement:
1- Replacement is the same as removal in reverse order. Make sure that stud (D) is
firmly located against link (E).
2- Adjust needle location in the needle plate slot (See pages 75-76) and needle to
hook relationship (See pages 77-78).
3- Check hook timing (See pages 91-92), needle bar height (See pages 67-68) and
adjust if necessary.
4- Adjust presser bar alignment and height. (See pages 87-88)
Take-up Lever Assembly and
Needle Bar Connecting Link
P/N 358426002
MAR/05
Rev. no.
To Next Page
Loading...
