Need help?Do you have a question about the Singer 9020 and is the answer not in the manual?
General| Type | Electronic |
|---|---|
| Stitch Width | 7mm |
| Max Stitch Length | 5mm |
| Max Stitch Width | 7mm |
| Presser Feet | All-Purpose Foot, Zipper Foot, Buttonhole Foot, Satin Stitch Foot, Blind Hem Foot, Overcasting Foot, Embroidery Foot, Darning/Freehand Foot |
Diagram illustrating the various parts of the Singer Model 9020 sewing machine for identification and reference.
Diagnosing and resolving issues preventing the sewing machine from powering up, focusing on power supply and switch problems.
Step-by-step instructions for safely replacing a damaged or faulty sewing machine power cord.
Detailed guide for safely removing and installing a new sewing machine power and work light switch.
Identifying common causes of skipped stitches, including lint, thread tension, needle condition, and timing.
Procedure to synchronize the shuttle hook and needle to correct skipped stitches.
Guidance on adjusting upper and lower thread tension for balanced and consistent stitch quality.
Instructions for cleaning lint and dust from the shuttle race and feed dogs for optimal performance.
Procedure for examining and replacing dull or bent needles to prevent skipped stitches.
Diagnosing and resolving issues causing the sewing machine to run slowly or with reduced power.
Step-by-step guide for safely replacing the drive belt to restore proper machine function and speed.
Detailed procedure for safely removing and installing a new drive motor, crucial for machine operation.
Diagnosing issues like disengaged clutch, broken belt, or gear failure affecting needle movement.
Identifying causes for motor failure, including foot pedal, wiring, and internal motor issues, and their solutions.
Instructions for replacing the foot pedal control if it fails to send power or regulate motor speed.
Resolving issues where thread bunches in the shuttle race, causing the machine to jam.
Diagnosing and resolving knocking sounds caused by lubrication issues or internal gear problems.
Addressing problems with feed dogs or stitch length settings preventing fabric advancement during sewing.
To Next Page
