18 – Operating Your Machine
English
18 – Operating Your Machine
English
Helpful Messages
Bobbin winder is moved to right (operating position) during sewing.
— Check bobbin winder and move it to left.
Buttonhole lever is not lowered or raised.
— Lower buttonhole lever when sewing buttonholes.
— Raise buttonhole lever when sewing stitch patterns.
Foot control plug is pulled out, while operating foot control.
— Push in foot control plug.
Machine is locked up due to thread entangled with bobbin case or rotation interrupted forcibly.
— Turn o power switch and eliminate the problem that caused the machine to stop.
Reverse/tacking stitch button is pushed, while buttonhole stitch is selected.
— Tacking stitch is made automatically after buttonhole stitch is completed. It is not necessary to
push the reverse/tacking stitch button.
Bobbin winder is in operation. Bobbin winder is in operation.
— Move bobbin winder to left when it is not used.
If an incorrect operation is made, a helpful message will be displayed. When a helpful message is displayed, x the problem following
the instructions below.
To Next Page
Loading...
