-3-
TO REPLACE THE NEEDLE
To replace the needle, raise
the needle bar to its highest
point by turning the hand
wheel (Fig. 3) TOWARD
YOU by hand. Loosen the
needle clamp screw (A) on the
right hand side, and the needle
clamp will open, allowing the
old needle to slip out.
Remove the old needle and
slide the new needle up,
(FLAT SIDE TO THE
RIGHT) as far as it will go.
When the needle hits the stop,
it is positioned correctly.
Tighten the needle clamp
screw securely. For best re-
sults change needle frequently.
Note: Use only
15X1, 705, or HAX1
class needles.
NEEDLES AND THREAD
Never use a bent needle, nor one with a blunt point, since this
causes imperfect stitches and may cause the needle to break.
Unless the needle is in all the way, flat side to the right, the ma-
chine will not function correctly, and you will not get good results.
The size of the needle should conform to the size of the thread,
and both should be suitable for the material being sewn. In most
applications, use the same thread top and bottom, and always use
good quality thread and needles.
To Next Page
Loading...
