-8-
TO PREPARE FOR SEWING
Thread machine as per pages 6 & 7.
Pick up the bobbin thread by holding the loose end of the needle
thread with your left hand while turning the hand wheel toward
you until the needle moves down and up and the thread take up
lever has reached its highest position.
Pull gently on the needle thread where it is looped down through
the needle plate, and the bobbin thread will come up through the
needle hole. (If the bobbin thread does not come up, recheck your
threading, and be sure that there is 4-5 inches of thread trailing
from the bobbin case.)
Finally, place both thread ends toward the rear of the machine,
with the needle thread going between the two presser foot toes
(A).
To Next Page
Loading...
