-6-
TO THREAD THE BOBBIN CASE
Hold the bobbin case between
the left thumb and forefinger
with the slot up. With 4 or 5
inches of thread trailing in the
direction shown…
...insert the bobbin into the bob-
bin case and pull the trailing
thread back into the slot, down
and to the left, until it snaps into
the “delivery eye” under the ten-
sion spring. When you pull on
the thread, looking at the bobbin
in the open side of the bobbin
case, the bobbin should rotate
clockwise.
There should be a slight but
consistent tension (drag) on the
thread as it is pulled through the
“delivery eye.” The tension can
be increased by turning the ten-
sion screw clockwise decreased
by turning it counter-clockwise.
To Next Page
Loading...
