53
HELPFUL MESSAGES WHEN EMBROIDERING
Display on control panel Situation
Embroidery unit is mounted, but USB cable is not connected.
or
USB cable is disconnected after transferring embroidery data. In this case, the image is
displayed for a few seconds, and then changed back to normal display. The transferred
embroidery data is still available in the machine.
USB cable is connected, but embroidery data is not transferred yet.
All LED lamps are turned off.
Embroidery data is being transferred.
All LED lamps are turned off.
Embroidery data has been completely transferred.
The number of the current color block (A) (number one directly after transferring) and total
number of transferred color blocks (B) are shown on the display.
Embroidery in progress.
The number of the currently stitched out color block (A) and total number of transferred color
blocks (B) are shown on the display. The status bar indicates how far in the color block the
machine has embroidered.
When last block or one unit of endless hoop is completed.
All LED lamps are turned off.
A
B
A
B
To Next Page
Loading...
