64
On control panel
Problem
¼
Correction
Sewing Embroidery
Breakage of top thread is detected.
Î
supply or rethread top thread and restart.
żż
Unable to start with needle lowered.
Î
Raise needle and restart.
ż
Unable to start with presser foot lifted.
Î
Lower presser foot and restart.
żż
Hoop size is too small to move hoop to original position.
Î
Turn off power switch and attach larger hoop.
ż
Hoop size is smaller than embroidery data.
Î
Attach appropriate hoop and restart.
ż
Defect in sewing data.
Î
Transmit correct data.
ż
1-17
(Error message
number)
System error occurs.
Î
Turn off and on power switch to eliminate the problem that caused the system error to
occur. If the error number should not disappear, consult an authorized technician.
żż
To Next Page
Loading...
