Singer SRP-50 - Page 22

., ______ ® .... ,
...... ~-----CD ,\
, ' I
I
I I
-- .. 1 J I I I I I I I I I I I till lll I II I I I I I I I I ..
1
/
\ ,
'... <2) ,
Q
1\
(3) Insert Wire through holes of Cast-on Comb teeth.
2. Hook Weights.
Use two Ribber Weights (large) and hook them onto
left and right sides of Cast-on Comb.
For your reference use up to 80 needles 2 Weights
120 needles 3 Weights
160 needles 4 Weights
200 needles 5 Weights
Hook Weights at even intervals.
0-4~6 Change machine controls for knitting subsequent
3 rows.
- 4 Set lett Set Lever to [!] and both Stitch Dials to
1, then move Carriage from the right to the left.
(Knitter
needles will knit the first row of the
subsequent rows.)
- 5 Set Cam Lever to SLIP ( e, S) and return Carriage
to the right . (Ribber needles will knit the second
row .)
- 6 Re-set Cam Lever to STOCKINET (/;\, 0) and
move Carriage once more from the right to the
left. (Knitter needles will knit the third row .)
CAST-ON IS COMPLETED .
Remove yarn end from Clamp.
8 Re-set machine controlt for working main knitting .
. ' ~ ~ .
(Needle arrangement for main ~bitting is the same as for
east-on.) .
1. Change Carriage settings.
· Set Lever (left) .... .. .............................. O
Stitch Dials (Knitter & Ribber) .......... 2
Other settings unchanged.
2. Knit 20 rows by moving Carriage smoothly across Needle
Bed .
Continue on next page .
- 18 -