Singer SRP-50 - Page 8

4. Bring down both Push-up Cams "F" forward.
= =
~----
':Jff}}f}ff}Jjfff}})JJJJ)JJ!j_
5. Hold Ribber with b th h d .
"G" on both s·d _o an sand msert Ribber Joiners
I es Into slots of Auxiliary Pieces "H".
It will
be easier to · t h .
left
side. mser t e nght side first, then the
G
CHECK POINT
Ensure Ribber Needle Bed is at its highest position .
If
not, push the Bed with both hands as f .
ar up as It goes .
6. Push Ribber on both ·d
i~ no clearance betwees~ ~i~~;a~ds Knit~?r" until there
· l1ary Piece "J". r topper I and Auxi-
Fasten both screws with Screw Driver "K ".
-4-