How to clean flakes coming out of my Singer Iron?
If flakes and impurities are coming out of your Singer Iron's soleplate holes, it's likely due to using hard water, which causes scale flakes to develop inside the soleplate. Perform Self-Cleaning one or more times, referring to the “Self-Cleaning” section of this manual.
Why is my Singer Iron leaking water from the soleplate?
Water may leak from the soleplate of your Singer Iron because the heat setting is too low to produce steam. Set the temperature to Max using the Temperature Control Dial. Also, ensure the Steam Selector is in the 'OFF' position while refilling the Water Tank. Avoid pressing the Steam Button too many times and too quickly; press it slower, only 2-3 times.
What to do if my Singer Steam Choice 1.0 Iron is plugged in but the soleplate is cold?
If your Singer Iron's soleplate is cold even when plugged in, try plugging it into another electrical outlet. Also, check if the plug is properly inserted. Ensure that the temperature setting isn't set too low; adjust it to a higher temperature.
How to fix damage to fabric from my Singer Iron?
If your Singer Iron is damaging fabric, the temperature setting may be too high. Follow the garment guide or test the inside of the garment before ironing, and adjust the temperature setting accordingly.
Why is my Singer Steam Choice 1.0 not releasing steam?
If your Singer Iron isn't releasing steam, check if the Water Tank has enough water. If the tank is low, fill it according to the instructions in the manual. Also, make sure the Steam Selector is in the Steam ON position.
What to do if my Singer Iron's Steam Burst is not working?
If the Steam Burst on your Singer Iron isn't working, first, check if the Water Tank is low and fill it according to the manual's instructions. If it's the first time you're using the feature, press the Burst of Steam Button a few times until steam is released.
Why is my Singer Steam Choice 1.0 Iron soleplate too cool?
If your Singer Iron's soleplate is too cool, the temperature setting is likely incorrect. Turn the Temperature Control Dial until you reach the correct, higher temperature setting.
What to do if my Singer Steam Choice 1.0 Iron's spray mist is not released?
If your Singer Iron isn't releasing spray mist, ensure the Water Tank is filled. If it is the first time using the spray function, press the Spray Button a few times until the spray mist is released.
Steps for initial setup and preparation of the iron before the first use.
Instructions on how to safely fill the iron's water tank with tap water.
Guide on adjusting the temperature control dial for different fabric types.
General| Model | Steam Choice 1.0 |
|---|---|
| Type | Steam Iron |
| Vertical Steam | Yes |
| Voltage | 220-240 V |
| Frequency | 50-60 Hz |
To Next Page