Singer Stitch Sew Quick - Page 3

Using Your Stitch Sew Quick Handheld Mending Machine
Figure #4
Figure #5
Lift the xing plate, making sure that you do not
push down the needle arm (it is possible to move
the arm by hand even when the appliance is locked).
Place the fabric under the xing plate. (See Figure #2)
Release the xing plate.
Before starting to sew, thread at least 5cm from the
needle back to the front. If it is necessary to thread
the needle, see “Threading” section.
Hold Stitch Sew Quick
™
with your right hand.
Supporting the appliance from below with other
ngers, place your thumb on the On/Off button.
(See Figure #3)
Slide the On/Off button forward with your thumb
to turn on the appliance. Use your left hand to
hold the fabric and control the direction and speed
of the fabric as you pull it out from the appliance.
Make sure that you do not pull the material from the
appliance too quickly. If you need larger stitches
are required, pull the fabric a little to the left while
continuing the sew. To get a straight stitch, follow
the middle line on the fabric xing plate. (See Figure 4)
To End Sewing - After completing the sewing
process, turn the rotating dial to raise the needle
to the highest position, then pull the thread out by
around 7.5cm with the help of the back of a seam
ripper or scissors. (See Figure #5)
3 ]
4 ]
5 ]
6 ]
Figure #6
Figure #7
Figure #8
2 ]