Table of Contents Previous Page | Next Page
TT700
13
THREADING THE MACHINE continued...
3. Turn handwheel toward you until take-up
lever is in highest position. Pass thread
through hole in take-up lever C from right
to left.
4. Turn handwheel toward you so that needle
lowers and thread guide D is accessible.
Place thread behind thread guide D to the
right side, and pull forward. The thread
guide will thread itself.
5. Turn handwheel toward you again to raise
needle to its highest position.
Feed wire needle threader through needle
eye from right to left.
Insert thread through wire loop and pull
needle threader back to the right.
The needle is now threaded.
WORKING LIGHT
Slide to "ON" Position for brighter area to
sew.
To Next Page
Loading...
