Table of Contents Previous Page | Next Page
TT700
20
STEP 2:
Use left index finger to pull bobbin case
toward the right and up, until lower half of
metal bracket touches angled edge of posi-
tion plate. Rotate handwheel until bobbin
case rests in correct position. Proceed to
step 3.
STEP 3:
Check bobbin case for' proper positioning.
Screw head should line up with seam in plas-
tic casing of machine. From side view, top of
bobbin case will be level with (or slightly
above) position plate.
To Next Page
Loading...
