OPERATING THE MACHINE
GTZZ14EJ&16EJ Operation Manual 7-5 © Dec 2021
Figure 7-4
5. After moving the machine, position machine on a
firm level surface.
6. Choke the wheels securely to prevent motion of the
machine.
7. Loosen the bolts on each drive hub, then reverse
the cover of drive hub.
8. Tighten the bolts and engage the drive hub.
9. Remove the chokes as necessary.
NOTICE
The allowable towing speed is 3km/h (1.9mph)，the
maximum towing distance is 1km (0.6mile)
OPERATION FROM
GROUND
UNSAFE OPERATION HAZARD
• Unless in emergency situations,
do not operate from the ground
controller when there are
personnel in the platform.
• Do not operate the machine if any
control handle or switch is not
returned to off position after being
released.
COLLISION HAZARD
When operating the boom, be sure
the area around or under the platform
is free of persons or obstacles.
Before operation:
1. Be sure the battery is well connected before
operating the machine.
2. Turn the Ground/Platform select switch on the
ground controller to Ground.
3. Pull out the red emergency stop button on the
ground controller to the ON position.
To position platform:
1. Move the enable switch and meanwhile move
upwards/downwards the main boom up/down
switch to raise or lower the main boom.
2. Move the enable switch and meanwhile move
rightwards/leftwards the main boom telescope
switch to extend or extract the main boom.
3. Move the enable switch and meanwhile move
upwards/downwards the foldable boom up/down
switch to raise or lower the foldable boom.
4. Move the enable switch and meanwhile move
downwards/upwards the turntable rotate switch to
rotate the turntable clockwise or anticlockwise.
5. Move the enable switch and meanwhile move
upwards/downwards the platform level switch to
level up or down the platform.
To Next Page
Loading...
