Sinocan T06-19 - Installing the USB Touch Driver


14
capabilities of your touchmonitor is sent to your video monitor adapter when Windows
starts. If Windows detects your touchmonitor, follow the instructions on the screen to
install a generic plug-and-play monitor. Refer to the appropriate section below for driver
installation instructions.

Installing the USB Touch Driver
Installing the USB Touch Driver for Windows 7, Windows XP
Insert the Touch Drivers CD-ROM in your computer’s CD-ROM drive.
If Windows XP, starts the Add New Hardware Wizard, then:
1. Choose Next. Select “Search for the best driver for your device (Recommended)”
and choose Next.
2. When a list of search locations is monitored, place a checkmark on “Specify a
location” and use Browse to select the directory on the Touch Drivers CD-ROM.
3. Choose Next. Once the Touch Drivers USB touchscreen driver has been detected,
choose Next again.
4. You will see several files being copied. Insert your Windows OS CD if prompted.
Choose Finish.
If Windows 7, XP, Windows 2000, Windows 98, or Windows Me does not start the
Add New Hardware Wizard:
NOTE: For Windows 7 and Windows XP/2000, you must have administrator
access rights to install the driver.
1. If the AutoStart feature for your CD-ROM drive is active, the system automatically
detects the CD and starts the setup program.
2. Follow the directions on the screen to complete the driver setup for your version of
Windows.
If the AutoStart feature is not active:
1. Click Start > Run.
2. Click the Browse button to locate the autorun.exe program on the CDROM.
3. Click Open, then OK to run autorun.exe
4. Follow the directions on the screen to complete the driver setup for your version
of Windows. For T06 series you have to select Resistive Touch button.