Audio operation & USB operation
You can connect the unit with Disc player/MP3 player/smart phone or other music device
via an audio cable or optical fiber cable.
Audio
1. Connect one end of 3.5mm audio cable to the Mp3 player’s line output/headphone and
the other end to the AUX IN socket on the rear panel of the unit (cable not supplied).
2. Press the SOURCE button or AUX button on remote control to enter the audio mode.
3. Control the playback only by your Mp3 player.
Coaxial 1/ Coaxial 2
1. Connect the Disc player using a lotus audio cable to COAXIAL 1/COAXIAL 2 sockets.
2. Press the SOURCE button or COAX 1 or COAX 2 button on remote control to enter the
COAXIAL 1 or COAXIAL 2.
Optical fiber
1. Use an optical fiber to connect the speaker with Disc player via OPTICAL socket.
2. Press the SOURCE button or press OPT button on remote control to enter optical mode.
Control the playback only by your Disc player/MP3 player, etc.
USB operation
1. Insert the USB stick into the USB port on the rear panel of the unit.
2. Press the SOURCE button or USB button on remote control to enter the USB mode.
3. Once the USB stick inserted, the unit will auto-detect the files and start playing.
4. Please refer to GENERAL OPERATION for playback control.
5. The USB port charges the device inserted to the USB port.
NOTE:
1. Depending on the amount of data and media speed, it may take longer time to read the
files stored in the USB device, this is not a malfunction.
2. The supported files format is MP3 with an extended name “.mp3".
3. For some music files, even though they are of the support format, the unit may not play
because of the format compatibility.
9
To Next Page
Loading...