Sinotec BTS-800 - General Operation; Basic Unit Operation; Playback and Settings Control

General operation
PREPARATION
Before power on this unit, please check if all the connections are right and safe. Then
connect the main power. Press the POWER SWITCH to power on the unit.
STANDBY MODE
Press the STANDBY button to wake up the unit or turn to standby mode.
SELECT MODE
Press the SOURCE button on the top panel or press the AUX, FM, USB, BT, OPT,
COAX 1, COAX 2 buttons on remote control to select one of the modes: Aux in, FM, USB,
Bluetooth, Optical, Coaxial 1, Coaxial 2.
VOLUME SETTING
Briefly press the VOL+/VOL- buttons to turn the volume to a comfortable level.
MUTE THE SOUND
While the unit is playing, press the MUTE button on remote control to mute the sound.
Press the MUTE button again or press the VOL+/- buttons to resume the volume level.
DISPLAY
Press the DISPLAY button on remote control to turn on or turn off the display light.
RESET
Press RESET button on remote control to resume the settings of the volume, sound field,
bass/treble to the default levels.
TONE SETTING
Press BASS+/BASS- or TREBLE+/TREBLE- buttons on remote control to adjust the level
of bass and treble.
SOUND FIELD SELECTION
Press ROCK, JAZZ, CLASS, VOCAL, DANCE, POP, FLAT buttons on remote control to
select the sound field: Rock, Jazz, Classic, Vocal, Dance, Pop and off.
PLAY/PAUSE
Press the button to pause the playing, press again to resume.
PREVIOUS/NEXT
Press the PREV or NEXT button to skip to the previous or next track.
NUMBER buttons
In USB mode, use the 0-9 NUMBER buttons on remote control to select the track directly.
In FM mode, use these buttons to select the frequency or stations. (Please refer to FM
operation for more.)
6