FM operation
1. Vary the antenna direction to get the best reception.
2. Up to 60 stations may be preset when turning on to radio mode with good reception.
3. The FM frequency is 87.5-108.0MHz.
4. Press SOURCE button on the panel or FM button on remote control to enter FM mode.
5. Press MO/ST button on remote control to turn stereo on, if the reception is not good
enough, you can not turn stereo on.
1. Briefly press the / buttons on remote control or press and hold the / on the
top panel to skip to the previous or next stations.
Select stations
Press SEARCH button on remote control to search stations from low to high frequency,
press again to stop.
2. Briefly press the / buttons on remote control to forward or backward the frequency
by step of 0.05MHz.
Search stations
Save stations
The unit can save as much as 60 stations as presets.
3. Press NUMBER buttons 0-9 on remote control to select stations.
E.g. to listen to station 15, press 1, then press 5, and it enters the station 15.
4. Use F button and NUMBER buttons 0-9 to select frequency.
E.g. to listen to frequency 105.30MHz, press 1, 5, 3, 0, then it enters the 105.3MHz.
(Pressing 1 will act as 10, and the last Zero must be input to enable the selection.)
To save the current station into the current preset, press the SAVE button directly on
remote control.
E.g. if you are listening to the station 13 of frequency 102.5MHz, pressing SAVE button,
the frequency 102.5MHz is saved as preset 13. Next time you select station 13, the
unit enters the 102.5MHz.
To save the station into the wanted presets.
First, use NUMBER buttons to select the preset numbers you want to save to. Then, use
the F button and NUMBER buttons to select the frequency. At last, press SAVE button.
E.g. if you want to save the frequency 99.8MHz into the preset 36, press 3, 6 to select the
preset number, then press F button and press 9, 9, 8, 0 to select the frequency, at last
press SAVE button to save 99.80MHz into preset 36.
7
To Next Page
Loading...