SINTERIT POWDER HANDLING STATION - Environment and Place of Installation

A. ENVIRONMENT AND PLACE OF INSTALLATION
WARNING!
• The PHS device may only be used with a vacuum cleaner having an explosion-proof certicate
(ATEX, INTERTEK).
• Sinterit recommends to use the PHS device solely with a vacuum cleaner delivered by Sinterit
or by one of the Company’s ocial distributors and from Sinterit offer.
• Sinterit is neither responsible for the operation of the PHS device nor for any defects or damages
if PHS device is used with a vacuum cleaner other than the one recommended by Sinterit. This
includes but is not limited to vacuum cleaners that may be provided by distributors or resellers
but from outside Sinterit`s offer.
• TO THE EXTENT PERMITTED BY APPLICABLE LAW, SINTERIT DISCLAIMS ALL WARRANTIES
AND CONDITIONS, WHETHER EXPRESS, IMPLIED OR STATUTORY, IN CASE OF THE PHS
DEVICE BEING USED WITH A VACUUM CLEANER OTHER THAN RECOMMENDED ABOVE.
WARNING!
• The PHS must be protected against atmospheric agents (rain, hail, snow, fog, dust in
suspension, etc.)
• An environmental temperature between 10°C and 40°C and relative humidity not above 70%.
Optimum operation of the device at a temperature of about 22°C.
• The work environment must be clean, well-enough lit, and devoid of any explosive materials
that may create an explosive atmosphere.
• The work environment must be well ventilated, adequately to its size.
• The PHS unit should not be located close to the air conditioner vents.
IMPORTANT!
• The product should be placed on a at, stable surface with sucient weight resistance as the
device weighs over 150 kg.
• The product will not work properly if it is set at an angle.
STOP!
Do not place or store the PHS:
• outdoors;
• near water, or heat sources;
• in areas with large amounts of dust;
• in places subject to shocks, vibrations, high temperature and/or humidity;
• extreme changes in temperature and humidity;
• near inammable and volatile substances, concentrated acids or corrosive vapors;
• in places easily accessible to children and animals.
STOP!
• The PHS must not be operated in a corrosive or explosive environment.
• Avoid using the device close to open ames or sources of heat.
5 | POWDER HANDLING STATION Manual