SINUS Tango Plus - Software Installation

1.7 Software installation
1.7 Software installation
First TANGO driver must be installed for that Tango_Plus is recognized via USB connection. Second Tango-
Utilities should be installed for configuration of Tango_Plus settings and export of data.
1.7.1 Tango_Plus driver installation
Please follow the instructions below to install the TANGO driver on a PC. You find the file on the enclosed
USB stick. Use the Windows Explorer to start the driver installation programme. Perform the install setting
and confirm always. Depending on the system performance this procedure may take a few minutes.
1.7.2 Tango-Utilities installation
Installing the software Tango-Utilities resembles the installation procedure of most Windows applications.
Follow the instructions below:
• Run the installation program (Tango_Utilities_Version.exe).
• The first window shows the software version. Click on
Next
to continue to the next window.
• Set the installation directory in the next window. Click on
Next
to continue to the next dialog.
• In this dialog you may specify the directory in the Windows Start Menu. Click on
Next
to continue to
the next dialog.
• This dialog summarizes your settings. Click on
Install
to confirm and continue.
• Finish the installation by clicking on
Finish
.
SINUS Messtechnik GmbH 11 of 47 Manual Tango_Plus