2 APPLIANCE
• Deviation from original factory calibration (checked during calibration but not saved)
Loss of calibration status is effected by:
• Switching off the device (except when the measurement start is scheduled with a preset start time)
• Switch off the device during measurement breaks in repeat mode
• Cancel of calibration
2.5.4 View measurement results on Tango_Plus
It is possible to view the measurement results on the device via: “Menu > Stored Files > [File] > View
Results”. There you find resulting level and resulting 1/3 octaves as well as information about calibration
status, microphone sensitivity and whether the microphone was dircetly connected or detached.
2.5.5 Print results
If a printer is connected, you may set results to be printed after the measurement (section 2.2.1) under:
Functions > Measurement Values > [Value] > Print Result. This is possible for all sound levels that result in
one number like for example L
Aeq
or L
CF max
. You are asked to print after each measurement automatically.
You may also recall a measurement and print the result via: Functions > Print Results.
Manual Tango_Plus 24 of 47 SINUS Messtechnik GmbH
To Next Page
Loading...
